THINKY MIXER （Non Vacuum）
The standard model of the non-vacuum THINKY MIXER series. Provides simultaneous processing of mixing, dispersing and deaeration of high-viscosity materials.
- MAXIMUM CAPACITY
・Supports a wide range of materials, including high-viscosity materials and nano fillers
・The 2 modes of mixing and deaeration achieve dispersion and deaeration of high-viscosity materials in a small amount of time
・Cold-insulated, heat-resistant adapter enables support of various material characteristics
・Wide variety of adapters for using various containers
・Memory and step-operation functions for controlling and executing operating conditions
・Unique air-cooling system
The centrifugal force of over 400G enables simultaneous processing of mixing, dispersion, and deaeration of various materials from low to high viscosities for general purposes.
Furnished with a deaeration mode that enables high-precision deaeration, this model shows excellent performance in deaeration of high-viscosity adhesives and materials whose viscosities are increased by added fillers. A wide variety of materials and uses are supported by using adapters for various containers. It is employed for production or research and development where small amounts of materials are prepared.
|Unit Dimensions/ Unit weight||H390×W300×D340（mm）Approx. 21kg|
*1：Total mass to mount on the cup holder, including materials, containers, and adapters.
*2：Contact us because the actual volume of mixing may vary depending on the containers, materials, and conditions.
|300 ml resin container|
|Power Supply||Voltage: Single-phaseAC 120 V ± 10 %, 50/60 HzPower consumption:Approx. 50 VA (standby)Max 900 VA (operation)|
|Accessories||Instruction Manual × 1AC cable (including 3P adapter) × 1,HDPE 300 ml container × 3,150 ml container × 1,Adapter for 150 ml container × 1(including 1 rubber ring)Key to unlock door during power failure (unit rear) × 1|